- A bobbed/ long haired model
- Tongs
- Combs/ brushes
- Hairspray
- Pins and grips
- Shine Spray
- Hot sticks
- Mason and Pearson (brush)
- Hood dryer
- Pli (heat protector)
- Extensions/ ready made hair pieces.
- Hair nets
Method:
- Create a side parting (go straight up from top point of arch in eyebrow).
- Plug in tongs. Use heat 20-23 (if models hair type is in normal/good condition, lower heat if it is brittle and dry).
- On the side with more hair, section from top of head to just behind ear.
- At the front of the style you want root lift- at the back you don't.
- Start with a section of hair at the front and tong all the way down to the root.
- Remove the hair from the tong keeping it in a solid barrel curl shape and pin with long metal grip through the curl on top of the head.
- If hair is very long you don't need to tong all the way to the ends of the hair as it will be tucked into the bob shape created later on.
- On the opposite thinner side of the hair, create 2 vertical barrel curls, curling towards the back of the head and pin in place with long metal grips.
- Then take the upper back section of the hair and create a layer of curls (from about half way down the hair to the tip) and pin to set.
- Then backcomb the rest of the hair from the underneath upwards.
- Put a hair tie round the ends of the backcombed hair and roll it upwards round 2 fingers creating a giant barrel curl.
- Secure in place with pins at the nape of the neck and up to the ears.
- Manipulate into place with the end of a pintail comb.
- Remove the layer of pin curls round the back of the head and break them apart with the end of the pintail comb so that it spreads over the surface of the bob.
- Gently back comb the dispersed curls with your fingers.
- Pin them in place at the nape of the neck underneath the bob.
- Remove the metal pins from the barrel curls at the top of the head.
- Brush through the curls and rub a small amount of vitapointe (a smoothing serum) into the curls and smooth them out.
- Use pintail comb to push the hair into a finger waves shape and weave pins into hair to secure it.
- With thinner side of the hair, sweep back and pin into place with 1 pin and leave the rest of the hair loose.
- Fix with hairspray and shine spray.
- If the front sections of hair hang lower than the bob, pin up in place with the rest of the bob.
I am quite pleased with the outcome of my first attempt at the 1930's style bob. However, next time I would curl a slightly thicker section of hair at the back of the head used to cover the bob as I could see some of the backcombing used to create the bob and it would have looked better if I couldn't see it.
No comments:
Post a Comment